FAQs
More FAQs- How long will it take to have my hard floors coated with urethane?
- When will I be able to walk on the carpet after it has been cleaned?
- Are there instructions to follow after my hard-surface floors are cleaned?
Preparation will depend on the condition of the existing floor, current number of coats, repairs required, etc. The coating application can be accomplished at a rate of 750 square feet per hour with a two-person crew.
This depends on whether a low-moisture encapsulation or a deep clean of your carpet has been applied. However, a general rule of thumb is to allow a drying time of six to eight hours before you can walk on your carpet.
Before you walk on your floors, it’s best to allow drying time of at least 4 hours but we recommend 8 hours. Be cautious and protect floors from getting wet for 24 hours after application of either finish as it is not yet thoroughly cured. You can return furniture to your floors (with suggested use of felt pads) after 24 hours and return rugs to floors after 24 hours.